Tag: sparkplug

165 – A Shop Towel in the Engine! Don’t Do What I Did!

January 22, 2021 / Dean Showalter / 2 Comments

Hi Friends!

I have a story for you today that I wish I didn’t have. But it’s true, so we might as well learn from it. Thankfully, everything turned out well on this one.

At Moody Aviation where I went to school years ago, we had a concept called “SYE.” It stood for “Share Your Experience.”

It was a concept to encourage us to take our mistakes and make a learning opportunity from them.

Listen to today’s podcast for the story of how I accidentally left a red shop towel inside an airplane engine… I hope I never do that again! Definitely an opportunity to learn “what not to do!”

Ok… it’s time to ‘fess up 🙂 I know I’m not the only one out here who’s done a dumb thing or two in airplane maintenance… so, if you’re willing to share your story, leave me a message here on the website, or shoot me an email dean{at}airplaneownermaintenance{dot}com

I’ll assume it’s ok to share the stories, without names (unless you ask me to share your name.) Thanks!

Another item we discussed in this episode is a Cessna 172 that would not start. It turned out to be a problem with the left magneto, but in the process of troubleshooting, we discovered the spark plugs had gone far too long without being cleaned.

Take a look:

And here’s the loose distributor electrode inside the magneto:

Other items we discussed in this episode:

An oil leak on a Twin Cessna (you might have seen the email I sent out about this.)
The items we used to fix that oil leak: Aviation Permatex, Continental silk thread P/N 641543 (If you only need a small amount, check with Fresno Airparts… they sell it for 20 cents per foot) and the third item used was Loctite 515. These 3 components, used properly, make an excellent seal for the oil pump cover.
Some interesting electrical information about a Cirrus SR22 – here’s the YouTube video I mentioned with some excellent visuals: https://www.youtube.com/watch?v=FCeHxk-fJvE

The post “165 – A Shop Towel in the Engine! Don’t Do What I Did!” appeared first on AirplaneOwnerMaintenance.com

143 – Oh No! A Lycoming Exhaust Stud Pulled Out!

May 30, 2020 / Dean Showalter / 2 Comments

Podcast: Play in new window | Download

Note: The “Safety Wire Like A Pro!” video training course is available for one more day at 20% off (use code “canard” for discount coupon.) Read about the training here:

https://airplane-owner-maintenance.teachable.com/p/safetywiring

Three stories for today:

Story #1:

A Lycoming exhaust stud pulled out.

It was disappointing, but turned out to be an inspiring learning experience.

A helicoil had previously been installed, which pulled out, and left a hole too big to install another helicoil (thread repair). Listen and find out how we solved the problem with a “Keensert” thread repair:

It worked fantastically!

Story #2:

Bad spark Plug.

We also talked in this episode about a bad spark plug and how we determined which one was bad, using the engine monitor system in a Cirrus SR22.

The EGT for cylinder #2 was higher than all the others because only one spark plug was firing in that cylinder which caused the exhaust gases to be hotter when they crossed the EGT probe.

It turned out the spark plug ceramic was cracked and the plug was not working at all: (I verified it using the spark plug tester.) There’s actually another crack on the other side of the ceramic as well.